If you have a Maytag washer in your home, it is likely that your Maytag washer has an agitator. An agitator is a central post that is located within the washer tub and helps move the clothes around during the washing cycle. Over time, the agitator can become worn and will need to be removed and replaced with a new one. Here are some steps to help you remove an agitator from a Maytag washer.
Step 1: Unplug the Washer
The first step to removing an agitator from a Maytag washer is to unplug the washer from the wall. This will ensure that you do not cause any electrical damage while removing the agitator. Once the power has been disconnected, you can move on to the next step.
Step 2: Remove the Top of the Washer
The next step is to remove the top of the washer. You will need to remove the screws that are located around the edge of the washer tub. Once the screws have been removed, you should be able to lift the top of the washer off.
Step 3: Remove the Agitator
With the top of the washer removed, you should be able to see the agitator. At this point, you will need to remove the bolts that are holding the agitator in place. Once the bolts have been removed, you should be able to pull the agitator out of the washer.
Step 4: Clean the Tub
Once the agitator has been removed, you should take the opportunity to clean the inside of the washer tub. Use a mild detergent and a cloth to clean the inside of the tub. This will ensure that the new agitator will fit properly.
Step 5: Install the New Agitator
Once the inside of the washer tub has been cleaned, you can then install the new agitator. Place the agitator into the washer tub and secure it with the bolts that you removed in the previous step. Make sure that the agitator is secure and that it is not loose.
Step 6: Reattach the Top of the Washer
Once the new agitator is installed, you can then reattach the top of the washer. Place the top back onto the washer and secure it with the screws that you removed in the previous step. Make sure that the screws are tight and that there is no gap between the top and the washer tub.
Step 7: Reconnect the Power
The last step is to reconnect the power to the washer. Plug the washer back into the wall and make sure that it is secure. Once the power is reconnected, you should be able to use the washer as normal.
Conclusion
Removing an agitator from a Maytag washer is a fairly simple process. All you need to do is unplug the washer, remove the top, remove the agitator, clean the tub, install the new agitator, reattach the top, and reconnect the power. With these steps, you should be able to remove and replace an agitator from a Maytag washer in no time.