The Ring doorbell is a device that allows you to monitor your home from anywhere. It is a great way to keep your home secure, but it needs to be recharged periodically. In order to recharge the Ring doorbell, it must be removed from its mounting bracket. This can be done by following a few simple steps.
Step 1: Prepare to Remove the Ring
Before beginning, make sure that the Ring is powered off. This can be done by going to the Ring app on your smartphone and pressing the power button. Additionally, you will need a Phillips screwdriver and a flathead screwdriver to remove the Ring. Finally, make sure that you are standing on a stable surface and have plenty of light.
Step 2: Remove the Outer Cover
Use the Phillips screwdriver to remove the screws holding the outer cover in place. Once all the screws are removed, the outer cover should lift off easily. Be sure to keep the screws in a safe place, as you will need them to replace the cover later.
Step 3: Disconnect the Wire Connectors
Once the outer cover is removed, you will be able to see the wire connectors that are connecting the Ring to the power source. Use the flathead screwdriver to carefully disconnect the wire connectors from the Ring. Be sure to pull the connectors straight out from the Ring, as twisting them can cause damage.
Step 4: Disconnect the Mounting Bracket
The last step is to remove the mounting bracket that is attached to the wall. Use the Phillips screwdriver to loosen the screws that are holding the bracket in place. Once the screws are removed, the bracket should slide out easily. Be sure to keep the screws in a safe place, as you will need them when re-installing the Ring.
Step 5: Remove the Ring
Now that all the connections are disconnected, you can carefully remove the Ring from the mounting bracket. Be sure to hold the Ring firmly, as it can be easily dropped. Once the Ring is removed from the mounting bracket, you can begin charging it.
Step 6: Re-Install the Ring
Once the Ring has been charged, it’s time to re-install it. First, connect the wire connectors that were disconnected earlier. Then, replace the outer cover and use the Phillips screwdriver to secure it in place. Finally, attach the mounting bracket to the wall and use the Phillips screwdriver to tighten the screws.
Conclusion
Removing the Ring doorbell to charge it is a relatively simple process. All that is required is a Phillips screwdriver and a flathead screwdriver. Start by powering off the Ring, then remove the outer cover and disconnect the wire connectors. Then, disconnect the mounting bracket and remove the Ring. Finally, re-install the Ring by connecting the wire connectors, replacing the outer cover and attaching the mounting bracket. Following these steps will ensure that your Ring doorbell is properly removed and re-installed.