A DirecTV remote control can be programmed to control any device that is capable of being connected to a DirecTV system, including TVs, DVD players, and audio systems. Programming a DirecTV remote is a simple process that requires just a few steps. In this article, we will discuss the steps required to program a DirecTV remote.
Step 1: Remove the Battery Cover
The first step to programming a DirecTV remote is to remove the battery cover. This will reveal the battery compartment, which contains two AA batteries. Remove the two batteries, and then replace the battery cover.
Step 2: Locate the Programming Code
The next step is to locate the programming code for the device you wish to control. The programming code can be found on the back of the DirecTV remote or in the owner’s manual.
Step 3: Enter the Programming Code
Once you have located the programming code, the next step is to enter it into the DirecTV remote. To do this, press and hold the “Mute” and “Select” buttons until the LED light turns on. Then, enter the four-digit programming code using the number keys on the remote. Finally, press the “Select” button to confirm the code.
Step 4: Test the Remote
Once the programming code has been entered, it is time to test the remote. To do this, press the power button on the remote. If the device turns on, then the remote has been successfully programmed. If the device does not turn on, then you should check the programming code and try again.
Step 5: Program Additional Devices
If you wish to program additional devices, then repeat steps 1-4 for each device. This will allow you to control multiple devices with one remote.
Step 6: Program the Universal Remote
If you have a DirecTV universal remote, then you can program it to control multiple devices with one remote. To do this, press and hold the “Mute” and “Select” buttons until the LED light turns on. Then, enter the four-digit code for each device using the number keys on the remote. Finally, press the “Select” button to confirm each code.
Step 7: Test the Universal Remote
Once the universal remote has been programmed, it is time to test it. To do this, press the power button on the remote. If all of the devices turn on, then the remote has been successfully programmed. If any of the devices do not turn on, then you should check the programming code and try again.
Step 8: Set Up the Remote
The final step to programming a DirecTV remote is to set up the remote. To do this, press and hold the “Setup” button until the LED light turns on. Then, use the arrow keys to select the device type and press the “Select” button to confirm. Finally, use the arrow keys to select the brand of the device and press the “Select” button to confirm.
Step 9: Customize the Remote
Once the remote has been set up, you can customize it to suit your needs. To do this, press and hold the “Mute” and “Select” buttons until the LED light turns on. Then, use the arrow keys to select the feature you want to customize and press the “Select” button to confirm. Finally, use the arrow keys to select the desired setting and press the “Select” button to confirm.
Conclusion
Programming a DirecTV remote is a simple process that requires just a few steps. By following the steps outlined in this article, you will be able to easily program a DirecTV remote and customize it to suit your needs. With a few simple steps, you can have a fully functioning remote that will make controlling your DirecTV system easier than ever.