Shiplap is an interior design trend that has been around for centuries. It is a type of wooden board with a beveled edge that creates a unique pattern when installed on walls. Not only does shiplap add a rustic, country charm to any room, but it is also easy to install.
Installing shiplap is a relatively easy DIY project. To get started, you’ll need to measure your wall and lay out the boards. Once you have determined the layout, you’ll need to cut the boards to length. Then, you’ll need to attach the boards to the wall by nailing them in place.
Preparing Your Wall
Before you start putting up shiplap, you need to prepare your wall. To do this, you’ll need to remove any existing trim or molding. Then, you’ll need to use a hammer and chisel to remove any nails or screws. Next, you’ll need to fill in any holes in the wall with spackle. Once the spackle has dried, you can sand it down to create a smooth surface.
Measuring and Marking the Wall
Once you’ve finished prepping the wall, you can begin measuring and marking the wall for the shiplap boards. Start by measuring the length of the wall and the height of the boards. Then, use a pencil to mark the wall with a level and a T-square. This will help you keep your lines straight and even.
Cutting the Boards
Once you’ve marked the walls, you can begin cutting the boards. Start by measuring the length of the boards that you need. Then, use a jigsaw to cut the boards to length. When cutting the boards, make sure to wear safety goggles and a dust mask to protect yourself from sawdust.
Attaching the Boards
Once you’ve cut the boards to length, you can begin attaching them to the wall. Start by laying out the boards on the floor. Then, use a drill to attach the boards to the wall with nails. Make sure to use nails that are long enough to penetrate through the shiplap and into the wall studs.
Filling in the Gaps
Once you’ve attached the boards to the wall, you’ll need to fill in the gaps. To do this, use a putty knife to spread wood putty or caulk into the gaps. This will help to create a seamless look and prevent any air or moisture from getting in.
Finishing Touches
Once you’ve finished attaching the boards and filling in the gaps, you’ll need to add some finishing touches. To do this, use a paintbrush to paint over the boards with a sealant or stain. This will help to protect the wood and enhance its natural beauty.
Conclusion
Installing shiplap is a great way to add a rustic, country charm to any room. It is a relatively easy DIY project that can be completed in just a few hours. To get started, you’ll need to prepare your wall, measure and mark the wall, cut the boards, attach the boards, fill in the gaps, and add some finishing touches. By following these steps, you’ll be able to enjoy your new shiplap walls in no time.